19
7. To exit the Settings Menu, press the POWER ON / OFF Button
twice, you will be prompted to press the SHOOT / RECORD Button
to confirm.
Follow the steps for all four Screen Saver options.
6.10 LED INDICATOR
The ZXM-AC2 has LED Indicator lights that indicate if a function is
active.
The LED Indicator on the top of the Unit notifies you when WiFi is
connected by a constantly flashing red light. There are also two small
LED Indicator lights on the left side of the screen:
•
The red LED Indicator light shows the ZXM-AC2 is currently charging.
• The blue LED Indicator light will stay solid blue when not recording,
and when recording, it will flash blue.
The ZXM-AC2 LED Indicator light settings can be adjusted from its
default setting of ON. To change this setting, follow the below steps:
1. Press the SHOOT / RECORD Button to end recording (if required).
2. Press the POWER ON / OFF Button four times, this will open up the
Settings menu. Press the SHOOT / RECORD Button to activate the
Settings page.
3. Press the POWER ON / OFF Button twice, this will open up the
ZXM-AC2 system Settings menu.
To Next Page
Loading...
