17
3. Press the POWER ON / OFF Button twice, to open the ZXM-AC2
system Settings menu.
4. Press the DOWN Button 3 times to navigate down the menu to
‘Rotate Image’. You will see this option highlight and a tick inside a
box will appear.
5. Press the SHOOT / RECORD Button to Rotate Image.
6. To exit the Settings, press the POWER ON / OFF Button twice, you
will be prompted to press the SHOOT / RECORD Button to confirm.
6.8 DVR MODE
When DVR Mode is activated, the ZXM-AC2 will continue to record
until the Unit has run out of power. To change this setting, follow the
below steps:
1. Press the SHOOT / RECORD Button to end recording (if required).
2. Press the POWER ON / OFF Button 4 times to open the Settings menu.
Press the SHOOT / RECORD Button to activate the Settings page.
3. Press the POWER ON / OFF Button twice, this will open up the
ZXM-AC2 system Settings menu.
4. Press the DOWN Button 4 times to navigate down the menu to
‘DVR Mode’. This option will be highlighted.
If this function is
activated there will be a tick in the box.
5. Press the SHOOT / RECORD Button to either activate or deactivate
‘DVR Mode.’
To Next Page
Loading...
