13
6.4 SETTING THE DATE & TIME
To set the correct Date and Time on your ZXM-AC2, follow the below
steps once your Unit is powered ON:
1. Press the SHOOT / RECORD Button to end recording (if required).
2. Press the POWER ON / OFF Button four times, this will open up the
Settings menu. Press the SHOOT / RECORD Button to activate the
Settings page.
3. Press the POWER ON / OFF Button three times, this will open up
the ZXM-AC2 hardware Settings menu.
4. Press the DOWN Button once on the right side of the Unit to
navigate down the menu to ‘Date-Time’.
5. Quick press the SHOOT / RECORD Button again once to open the
Date/Time Settings. A screen will appear with the Date and Time.
NOTE: The number which has a highlighted blue box can be
changed with the up and down Buttons. The date is set as
DD/MM/YYYY, and the time is 24 hour set as HH:MM:SS.
5. Set the correct Date and Time. Once you have adjusted the first
value, press the SHOOT / RECORD Button to jump to the next
value (you will notice the next value will now highlight a blue box).
To Next Page
Loading...
