ZERO-X ZXM-AC2 - Screen Saver

18
6. To exit the Settings menu, press the POWER ON / OFF Button twice.
You will be prompted to press the SHOOT / RECORD Button to exit.
6.9 SCREEN SAVER
The Screen Saver function allows you to use your action camera but
also conserve power, by allowing the LCD display to turn OFF while the
camera continues to record.
There are four options to activate within this function, however the
default time setting is 20 seconds. To change the this setting, follow
the below steps:
1. Press the SHOOT / RECORD Button to end recording (if required).
2. Press the POWER ON / OFF Button four times, this will open up the
Settings menu. Press the SHOOT / RECORD Button to activate the
Settings page.
3. Press the POWER ON / OFF Button twice, this will open up the
ZXM-AC2 system Settings menu.
4. Press the DOWN Button 7 times to navigate down the menu to
‘Screen Saver’. This option will highlight when selected.
5. Quick press the SHOOT / RECORD Button again once to open the
Screen Saver Settings. Four options will appear on the menu: 10
seconds, 20 seconds, 30 seconds and OFF.
Press the UP / DOWN
Button
to the option you require.
6.
Press the SHOOT / RECORD Button to select.