ZERO-X ZXM-AC2 - Firmware Version

32
10.0 FIRMWARE VERSION
To check the current Firmware Version of your ZXM-AC2, follow the
below steps:
1. Press the SHOOT / RECORD Button to end recording if you are in
video mode and recording.
2. Press the POWER ON / OFF Button 4 times, this will open up the
Settings menu. Press the SHOOT / RECORD Button to activate the
Settings page.
3. Press the POWER ON / OFF Button 3 times, this will open up the
ZXM-AC2 hardware Settings menu.
4. Press the DOWN Button 4 times on the right side of the Unit to
navigate down the menu to ‘Firmware Version’. Press the SHOOT /
RECORD Button once to open up the firmware information.
5.
To exit the ‘Firmware Version’ press the POWER ON / OFF Button
twice, you will be prompted to press the SHOOT / RECORD Button
to confirm exiting.
To check if a new Firmware Version is available for your action camera or
for instructions on how to update it on your action camera, please check
our website.
www.zero-x.com.au | www.zero-x.co.nz