111
HYDRAULIC SYSTEM
F 159 F 160 F 161
CAB CONTROL SWITCH
Cab control switch is used for lifting the
implement when turning the tractor in the
end of field. Pressing the switch lifts
implement. Implement is lowered into
previous position destined by inner
circuit lever after turning the switch into
off.
CONTROL SWITCH ON FENDER
Control switch on fender makes
attaching the implement easy. Driver can
handle movement of three point hitch
lower links from outside. The hitch is
lifted when the switch is pressed. The
implement is lowered into previous
position destined by inner circuit lever
after releasing the switch.
When the tractor is equipped
witch pick up hitch do not lift the
rear three point hitch by switches
on fenders up to the highest
position! Danger of damaging the
hitch!
USE OF SWITCHES
Operator must stand outside the
operating range of attached im-
plement when manipulating with
three-point hitch by means of
electrical switches to avoid
catching by implement or injury.
For lifting the implement into transport
position you must use the control lever
of inner circuit. Move the lever into upper
position. The implement must be
lowered to ground when stopping the
tractor with attached implement (the
implement must not be left in lifted
position).
PDF byl vytvořen zkušební verzí FinePrint pdfFactory http://www.fineprint.cz
To Next Page
Loading...
