168
MAINTENANCE INSTRUCTIONS
F 234 F 235 F 236
INSPECTING THE ENGINE OIL LEVEL
Daily inspect the oil level before starting
the work. Inspect the oil level with tractor
in horizontal position. Remove the oil
dipstick (1) wipe it with cloth and thread
it. The oil must not be under lower
dipstick mark after repeated removing
the dipstick.
Add the oil into filler (2) if needed.
DRAINING THE ENGINE OIL
Drain the oil by removing the draining
plug. Drain it immediately after stopping
the tractor or after preheating the engine
to working temperature. Clean the
draining plug before reassembling.
Check for the good status of sealing
ring.
CHANGING THE FULL-FLOW
CLEANER OF ENGINE OIL
The engine oil cleaner is exchanged
ever when changing the engine oil.
Before assembling a new cleaner clean
the sealing area of cleaner support (2)
and cleaner body (1). Coat the rubber
sealing by the same oil you will fill into
the engine. Assemble the new cleaner
and tighten it by hand. Tighten again the
oil cleaner by 3/4 to 1 1/4 turns after
touching sealing to block. Check the
cleaner for leakage after starting the
engine.
PDF byl vytvoren zkusebnı verzı FinePrint pdfFactory http://www.fineprint.cz
To Next Page
Loading...
