136
HITCHES
F 194 F 195
ATTACHING MACHINES TO THREE POINT HITCH WITH CBM HOOKS
Lower and upper links of hitch are equipped with semi-automatic ends -CBM.
They serve for easy, two-phase attaching and
disattaching the implement to
the three point hitch without necessary direct action of the driver. They are
operated by means of cables from the driver’s place. Lower links are attached to the
implement within the first phase at reverse move and by subsequent lifting the three
point hitch. Top link of three point hitch is attached by the driver from the cab within
the second phase. The top link is assembled in one from four openings of the
support. First the implement must be equipped with attaching balls-CBM and the
length of hitch axis must be adjusted with adjustable spacer (at reinforced three point
hitch only).
At tractors equipped with reinforced three point hitch “ CBM, the fine adjustment is
carried out by moveable collar with handles.
The collar of lift link must be ever set with handles in direction of driving after
adjusting the length.
LOCKING THE SIDE SWING OF
LOWER LINKS
Insert the pin (1) into opening II
(implement of category II) or into
opening I (implement of category I).
Hitch is set in the middle position. Fine
adjustment of hitch can be done by
means of bolt (2). Blocking the side
swing of links is done when transporting
the implement or when working with
machines which need precise towing
behind the tractor.
At reinforced three point hitch the
stabilizers can be adjusted within their
whole range by rotating the collar.
PDF byl vytvořen zkušební verzí FinePrint pdfFactory http://www.fineprint.cz
To Next Page
Loading...
