135
HITCHES
F 192 F 193
SAFETY REGULATIONS FOR
WORKING WITH THREE POINT HITCH
Non authorized persons who are
not charged to handle with
implements attached to tractor
must not be left between tractor
and attached implement - (A). Do
not park the tractor with imple-
ment in lifted position - (B).
ATTACHING MACHINES TO THREE POINT HITCH
The left lift link (1) is intended for course vertical adjustment of lower link position
and is adjustable after disconnecting its upper end from lift arm pin. Fine adjustment
is carried out by turning the tube of right lift link (2) with handle. Lower link ends can
be mutually vertically adjusted within range 200 mm. Floating (free) position of
implement and swinging round the axis is enabled after moving the pin (3) into the
lower opening (4). In this case the lower draft link ends can be freely vertically
moved by 100 mm one to each other. Lower link stabilizers (5) serve for limiting the
side to side swing of lower links. The side swing of lower links can be max. 100 mm
to each side from middle position when connected the implement of category II (125
mm at reinforced three point hitch). The side swing can be limited by locking of
stabilizers.
PDF byl vytvořen zkušební verzí FinePrint pdfFactory http://www.fineprint.cz
To Next Page
Loading...
