UNItivity 5000 Installing Remote Units
User Manual
Copyright © 2022 Zinwave. All rights reserved. 6-1
6 Installing Remote Units
This chapter describes how to install the Remote Units along with their power options.
6.1 Mounting Remote Units
Your system installation plan provides the locations to mount each Remote Unit and their associated
antennas. Depending on the available wall space a Remote Unit can be mounted vertically (with
antenna connector closest to ceiling) or horizontally (with antenna connectors facing a side wall).
Remote units can also be mounted to the ceiling.
Remote Units are suitable for use in environmental air space in accordance with Section 300-22(c) of
the US National Electrical Code, and Sections 2-128, 12-010(3) and 12-100 of the Canadian Electrical
Code, Part 1, CSA C22.1.
Tools:
• Drill with M4 bit
• Pencil
• M4 Screw driver
Supplied equipment:
• Remote Unit
• Zinwave Patch Cords
• Mounting Bracket
• 4x M4 screws
• RAWL Plugs
6.1.1 Considerations before Mounting
The Remote Unit (with mounting bracket) has the following dimensions displayed in millimeters:
To Next Page
Loading...