ZKTeco Notus - Verification Modes

Notus User Manual
Page | 14 Copyright©2021 ZKTECO CO., LTD. All rights reserved.
Terminal Resistor
6
ON
Restore to Factory Settings 1.6
There is a Reset button at the bottom of the device. Press it and hold for 5 seconds, the device will
restore to the factory settings (Note: The user data will not be deleted).
2 Instructions to Use
Finger Positioning 2.1
Recommended fingers: Using Index, Middle, or Ring finger is recommended. Avoid using the Thumb
or Little finger, as they are difficult to accurately press onto the fingerprint reader.
Press your finger firmly onto the fingerprint reader. Ensure that the center of your finger is aligned
with the fingerprint reader.
Too close to the edge
Vertical
Too low