on Receiver, or is directed to all the employees, by setting to ON the Public field.
3. When clicking on Receiver, an Employee selection screen will open, in order to
select the employees that are going to receive the message. Notice that it is
possible to select all the employees, this will NOT make the message Public, as
Public messages are delivered without punching, and a Message configured like
this will not. Once the employees have been selected. Click OK
4. Start and End Time mark the time in between the message will be shown. Both
options show the same options. First, the date of start/end is asked.
To Next Page
Loading...
Need help?
General
