H.264 Super Digital Video Recorder User Manual
34
lower Stream statics, the worse recording stream statics quality and occupies less
HDD capacity.
Recording plan: Set DVR’s recording plan
Picture 4.5 Recording Plan
Channel: Choose the corresponding channel number to set the channel. Choose the all option to
set the entire channels.
Redundancy: Choose the redundancy function option to implement the file double backup function.
Double backup is writing the video files in two hard disks. When you do the double
backup, make sure that there are two hard disks installed. One is read-write disk and
the other is redundant disk. (Pls refer 4.7.1 HDD manage to have detailed setting
methods)
Length: Set the time length of each video file. 60minutes is default value (A maximum of 120
minutes).
Pre Record: Record 1-30 seconds before the action. (Time length is decided by the code stream)
Mode: Set video state: configuration, all or stop.
Schedule：Record according to the set video type (common, detection and alarm)and time
section.
Manual: after choosing manual button, the related channel will carry common recording
whatever state the current channel is.
Stop：Click the stop button and the according channel stops recording no matter the channel
in any state.
Week: set (Monday to Sunday) or full week to record, it will just record in set days
Period: Set the time section of common recording, the recording will start only in the set range.
Recording type: Set recording type: regular, detection or alarm.
Regular：Perform the regular recording in the set time section. The video file type is
“R”.
Detect：Trigger the “motion detect”, “camera mask” or “video loss” signal. When
above alarm is set as opening recording, the “detection recording” state is on. The
To Next Page
Loading...
Need help?
General
