H.264 Super Digital Video Recorder User Manual
36
Picture 4.7 network service
【PPPoE setup】
Picture 4.8 PPPOE
Input the user name and password that ISP（Internet service provider）provides. After saving it
reboot up your system. Then the DVR will build a network connection based on PPPoE. The IP
address will change into dynamic IP address after above operation is well done.
Operation：After PPPoE dialing successfully look up the IP address in the IP address and obtain
the current IP address. Then use this IP address to visit the DVR through user port.
【NTP setup】
Picture 4.9 NTP
Server IP：Enter the NTP server address.
Port：Default: 123. You can set the port according to NTP server.
Time zone：London GMT+0 Berlin GMT +1 Cairo GMT +2 Moscow GMT +3 New Delhi GMT
+5 Bangkok GMT +7 Hong Kong Beijing GMT +8 Tokyo GMT +9 Sydney GMT +10 Hawaii
GMT-10 Alaska GMT-9 Pacific time GMT-8 American mountain time GMT-7 American mid time
GMT-6 American eastern time GMT-5 Atlantic time GMT-4 Brazil GMT-3 Atlantic mid time GMT-2.
To Next Page
Loading...
Need help?
General
