Safety instructions 12
3.5.2 Release button
If people are trapped in the compaction mechanism, use the release button / . It also
works when the emergency stop button is activated. Check the correct functioning of the
release button before each start-up!
3.6 WHAT TO DO IN AN EMERGENCY
1. Press the emergency stop button. Body will stop working.
2. Stop the vehicle immediately.
3. Do not turn off the engine or auxiliary drive of the vehicle.
4. Release trapped people using the release button. The release button is also active after
using the emergency stop.
5. Determine the cause and rectify any defects.
6. Unlock the emergency stop button by pulling or turning it.
7. Restart the body.
3.7 ADDITIONAL SAFETY INSTRUCTIONS
o If the safety instructions on the vehicle and the instructions in the manual are not
observed, real life and health risks to personnel and bystanders may arise.
o Maintain special caution when the visibility of the work area is limited.
o During work, pay attention to sufficient lighting of the work area. Before starting the
body, make sure that the lighting installation is functional.
o In the event of a power failure on the body, notify Zoeller immediately. If necessary,
check the fuses of the individual body functions (see chapter 8.6 Fuses).
o If the operator cannot see the work area, he should, if possible, ask a second person to
supervise the space behind the vehicle.
o When reversing, a second person should always supervise the space behind the vehicle.
o The vehicle driver should adapt his driving style to the specific body characteristics. In
particular, pay attention to:
• Vehicle overhang when cornering
• Total height of the vehicle
• Variable distribution of load during operation
To Next Page
Loading...