Operating instruction 27
1. Press the emergency stop button . Body will stop working.
2. Stop the vehicle immediately.
3. Do not turn off the engine or auxiliary drive of the vehicle.
4. Release trapped people using the release button . The release button is also
active after using the emergency stop.
5. Determine the cause and rectify any defects.
6. Unlock the emergency stop button by pulling or turning it.
7. Restart the body.
Do not use release button as a replacement for the press up button !
In an emergency, use the emergency stop button! To restore vehicle functions after pressing the
emergency stop button, turn the button clockwise. Do not use a vehicle with an inoperative emergency
stop or release button.
6.3 STARTING AND FINISHING A WORKDAY
6.3.1 Start
Before starting work, proceed as follows:
o Make sure you have unlocked all the emergency stop buttons
o For safety reasons it is recommended to activate the handbrake.
o Set the gearbox to neutral, if necessary, manually engage the auxiliary drive. Detailed
conditions for switching on the auxiliary drive are contained in the chassis manual.
o Start the vehicle engine.
The manufacturer's guidelines for using the auxiliary drive must be followed.
o Switch on the body. Turn on the ZCS Command module (for more information see ZCS
Terminal manual
o Weight the footboards according to the information on the terminal (if they are
installed).
To Next Page
Loading...