Zoeller MEDIUM X2 - Travelling

Operating instruction 29
Step 3
Scraper closes and empties the hopper by moving waste
towards the pushing wall.
Step 4
Slider moves up with closed scraper and compacts the
waste in the body.
In order to start the collection of waste, perform the actions described in section 6.3.1, and
then:
1. Press the START button that starts the cycle. Number of press cycles is set on the
terminal (see ZCS Terminal manual). After starting the press, the loading process can
be started.
2. Load waste. Do not load waste above the level of scraper in extreme upper position of
press.
3. To continue travel, press the signal button .
4. A signal to continue driving is heard in the driver's cab.
5. The moment the gear is engaged, the body is automatically turned off. At the next stop,
the auxiliary drive and body should engage automatically when the gearbox is in
neutral. If this function is not installed, repeat the steps in chapter 6.3.1.
6.5 TRAVELLING
In case of long drive:
o Set compaction mechanism on the position: slider in highest position, scraper closed.