Operating instruction 32
6.7.2 Unloading mode – outside control elements
All information on operating inside the body during unloading mode can be found in the operating
manual of the terminal in the driver's cab.
1. Raise the tailgate from the terminal (see: ZCS Terminal manual).
2. Eject the pushing wall. Body will be emptied. Leave the pushing wall in position on the
back of the body.
Depending on the type of the vehicle, the pushing wall may extend beyond the outline. If it does not
retract automatically when closing the tailgate, the wall should be moved back to level with the edge of
the body.
3. Start the tailgate closing function using the buttons . For security reasons,
these buttons are equipped with a time lock and require two hands to be operated
simultaneously. This means that you must press both buttons at the same time and
hold them down throughout the entire movement - releasing one or both buttons stop
the movement.
4. Keep the buttons pressed until the tailgate is properly closed and secured.
To Next Page
Loading...