Maintenance 37
8 MAINTENANCE
8.1 MAINTENANCE SAFETY
o Maintenance and repair work may only be carried out by the manufacturer or
authorized people.
o Health and safety regulations must be observed during maintenance work.
o When working on hydraulic power units or hydraulic components, they must first be
relieved of pressure to avoid the risk of injury, explosion or fire.
Before starting maintenance or repair work, stop the vehicle, switch off the terminal and secure it against
being switched on again, then switch off the vehicle by removing the key from the ignition!
o Be careful when turning the power off and on again! Do not turn off the main switch
while driving, otherwise the travel restrictions will be activated.
o All moving parts must be secured against accidental displacement during maintenance
and repair work.
o When opening the inspection door, the hydraulic system and all body functions must
be switched off.
o Damaged or missing information and warning labels need to be replaced immediately
with new ones.
o Before commencing welding work on the body, disconnect the vehicle battery and pull
out the plugs of the control devices. Also observe the chassis manufacturer's welding
instructions!
o After completing maintenance work, properly install all dismounted parts.
o Unauthorized structural modifications may not be carried out as they may reduce the
safety of personnel and the vehicle.
o Use only original spare parts.
To Next Page
Loading...