o In the case of vehicles with electronic engine control system or programmable modules,
any change of the factory-set parameters without the consent of the service is not
allowed.
o Implementation of any unauthorized changes not only creates potential threats, but
also leads to the loss of warranty rights.
o The press must be additionally secured by appropriate means (e.g. beam, chain) due to
possible movements caused by gravity.
o When carrying out maintenance work inside the vehicle, there must be an additional
belayer outside!
o When carrying out maintenance work inside the vehicle, the inspection door must
always be open.
o When raising the tailgate, it is forbidden to stand on the footboards.
o When working on a raised tailgate, it must be supported by supports (Fig. 8.2). It is
forbidden to lean on the road.
o Security seals may only be removed by authorized people. After completing
maintenance work, new seals must be fitted!
o If the user needs to enter the body, e.g. for inspection or maintenance, turn off the
vehicle's engine and remove the ignition key. The key should be stored out of reach of
unauthorized people.
When performing maintenance on the roof of the vehicle:
o Be extremely careful.
o The regulations for working at heights must be observed.
o Use personal protective equipment (in particular a helmet, work gloves).
o If necessary, ask for assistance from another person.
o Take precautionary measures against falling.
o Do not step on the roof of the tailgate.
Flexible hydraulic hoses must be replaced every 6 years, also when they do not show any
defects affecting safety.
Vehicle spare parts are listed in the spare parts catalogue supplied with the vehicle.
To Next Page
Loading...