6. Instructions on Sewing Operations
⑦ At Last Stitch
The needle rod stops at the upper position
of needle. Step start pedal (7) at this time.
(Hold it until the cloth-feeding board
returns to the position for laying cloth.)
In thread-trimming actions, when the
cloth-feeding board returns to the position for
laying cloth, the system will hint “END OF
MANUAL MODE” in the operation panel.
Caution：
When setting knife action as
“Cut-after-Sewing”, user shall look out the
action of knife.
6-3 Pause Switch
Pause in Auto Sewing
The pause switch is generally used for
stopping the sewing machine at thread-breakage
and other circumstance
6-3-1 Methods for Pausing
Du
ring the sewing, press the pause switch
(1) to stop the sewing machine, and then the
operation panel will hint “InstancyStop Error”.
36
To Next Page
Loading...
