ZOJE ZJ5821 - Initialization of Parameters

7. Interface of Parameter Setting Mode
No. Functions Description Range Changing Default
Step Setting
detection
adjustment
detection
U912 Main motor type
0：360 wire motor
1：256 wire motor
0~1 1 0
U913 DIP1
Temporary adjusting parameter
（reserved）
-100~100 1 0
U913 DIP2
Temporary adjusting parameter
（reserved）
-100~100 1 0
7-7 Initialization of Parameters
① In level 2 of setting mode, press to have
access to interface of parameter initialization, as
shown in right:
可以选择：
User can select:
（1）LEVEL1：Para. And C Program ( Level S pattern
parameter and C pattern cycle program)
（ 2） LEVEL2： Storage Data (Including U level
parameters)
（3）LEVEL3：All Internal Data
（4）LEVEL4：Initialize U disk
The detailed initialization content is at below：
Level, Content & Clear of Initialization
LEVEL1 LEVEL2 LEVEL3
Program
Content
Default
value
— Default
value
Cycle program Clear — Clear
Storage switch — Default
value
Default
value
Program code 1 — 1
Parameter code 1 — 1
Production
counter
— — 0
Mode Program — Program
Position for
locating cloth
Built-in — Built-in
Knife action OFF — OFF
56