Zoom 4506 - Appendix B: How to Set up Tethering on the Iphone

Appendix B: How to Set Up Tethering on
the iPhone
®
These instructions are based on using the iPhone in the USA with Verizon and AT&T, and may
vary slightly depending on the model of your iPhone, your firmware version, and service
provider. These instructions assume that you have a service contract that supports tethering.
Please consult your iPhone
®
user manual for more information.
1 Connect one end of the USB cable to the Router and the other end to the iPhone
®
.
2 Turn on tethering on the iPhone
®
. For GSM models used by AT&T, select Settings Æ
General Æ Network Æ Internet Tethering. For CDMA models used by Verizon,
select Settings Æ General Æ Network Æ Personal Hotspot.
3 Note: If you see a choice between Bluetooth
®
tethering or USB, you need to select
USB.
For most carriers you will need to set up your APN information in the router. To do this
first enter the router Configuration Manager, then select Basic Settings Æ Basic
Setup. On the Basic Setup page, enter the APN settings for your provider. If you don’t
know the APN settings please contact your provider or see Appendix A, which contains
the settings for many of the most popular wireless providers.
For example, if you are using your iPhone
®
with AT&T, use the following settings for the
items shown:
Item Setting
APN WAP.CINGULAR
Username WAP@CINGULAR.COM
Password CINGULAR1
Dial Number Leave blank
63