27
ZOOM G2Nu/G2.1Nu
Set the control parameter and
adjustment range
1. Select a patch that uses the expression
pedal.
WhenusingtheG2Nu,connectanoptional
expressionpedal(FP01/FP02)totheCONTROL
IN jack.
2. Set the module selector to "TOTAL" and
use the effect type [▼]/[▲] keys to select
"RTM."
3. Turn Parameter knob 1 to set the module to
be controlled by the expression pedal.
OntheG2.1Nu,youcanalsousethePEDAL
ASSIGN key to set the module controlled. The
indicator lights next to the selected destination.
Destination
(DEST) display
OFF (None) (None)
VOLUME VOLUME Volume
EFX EFX EFX module
DRIVE DRIVE DRIVE module
MOD MODULATION MODULATION module
DELAY DELAY DELAY module
REVERB REVERB REVERB module
• IntheEffectTypeParameterssection,apedal
icon appears next to effect types/parameters
that can be controlled by an expression pedal
(→P33–48).
• Whensetto"VOLUME,"thevolumecannot
exceed the range set by the master level and
patch level parameters.
• Forsettingsotherthan"VOLUME,"ifyoupress
the built-in expression pedal until it stops and
then push it down farther, you can turn the con-
trolled module ON/OFF.
• WhenthecontrolledmoduleisOFF,theindica-
tornexttoitblinks(ontheG2.1Nu).Inthis
state, you can press hard on the built-in expres-
sion pedal to turn the module ON, or choose a
different module to be controlled.
4. Use Parameter knobs 2 and 3 to change the
adjustment range of the control parameter.
UseParameterknob2tosettheminimumvalue
(MIN)andParameterknob3tosetthemaximum
value(MAX).Therangethatcanbesetdepends
onthecontrolledmoduleselectedinstep3.
UsinganExpressionPedal
UsetheG2.1Nu'sbuilt-inexpressionpedaloranoptionalconnectedexpressionpedal(FP01/FP02)tocontrolvolume
and effect parameters in real time.
Set range
(maximum)
Select control
destination
Set range
(minimum)
Parameter value
When MAX > MIN
MAX
MIN
Parameter value
When MAX < MIN
MAX
MIN