Zoom G2.1NU - Select a Patch and Play (Play Mode)

8
ZOOM G2Nu/G2.1Nu
Select a Patch and Play (Play Mode)
1.Turnthepoweron
2.Settheunittoplaymode
Minimize the volume of the amp.
When using an amp, turn its power on and raise its volume.
Turn the module selector to "PLAY."
Turnoneoftheparameterknobs(1–3)toopenthefollowingscreen.
■ When using batteries
TurnthePOWERswitchON.
■ When using an AC adapter
ConnecttheACadapter,andturnthePOWERswitchON.
HINT
TurnthePOWERswitchOFFandconnecttheUSBconnectorto
acomputertooperatetheunitusingbuspower(→P29).
HINT
Immediately after turning the power ON, play mode is
activated regardless of the position of the module selector.
HINT
• Ifyoudonotsavechangedparameters(→P22),allchangeswillbelost
when you select a different patch.
• Whenusingheadphonesoramixer,werecommendthatyouusethedirect
mode(→P24),whichsimulatesthesoundofaguitarcabinet.
• Adjustthevolumeforallpatchesusingthemasterlevel(→P30).
Functions of
Parameterknobs1–3
Current settings of
Parameterknobs1–3
Patch name
Bank name/
patch number
DRIVEmoduletone
Patch volume
DRIVEmodule
distortion depth