EasyManua.ls Logo

Zoom G2.1NU - Troubleshooting; Common Operational Issues; Effect, Pedal, and DAW Issues; Battery and Sound Quality Problems

Zoom G2.1NU
58 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
49
ZOOM G2Nu/G2.1Nu
Troubleshooting
● TheunitwillnotturnON
• ConrmthatthePOWERswitchissetto"ON."
• Whenusingbuspower,conrmthattheswitchis
"OFF"beforeconnectingtheUSBcable.
• Whenusingbatteries,conrmthattheyarestill
charged.
● Nosoundorverylowvolume
• Checktheconnections(→P4–7).
• Adjustthepatchlevel(→P20).
• Adjustthemasterlevel(→P30).
• When adjusting the volume withanexpression
pedal, make sure that a suitable volume setting
has been set with the pedal.
• Conrmthatunitisnotinmutemode(→P10).
• Theunitmighthaveswitchedtostandbytosave
power(→P5,7).Instandby,audioinputand
output are disabled.
● Thereisalotofnoise
• Checktheshieldedcablesthatyouareusingfor
defects.
• UseonlyagenuineZOOMACadapter.
• TryadjustingtheZNRmodulesettingsagain.
● Cannotchangepatches
Theunitmightbein"pre-selectmode"(→P25).If
it is, turn the power OFF and ON again to restart in
the normal mode.
● Soundisdistorted/toneisextreme
• Tryadjustingthe GainandLevel parametersof
theDRIVEmodule.
• Theunitmightbeindirectmode(→P24),which
simulatesthesoundofanampliercabinet.
● Thereverbeffectisnotworking
Iftheunitisinrhythmmode,theREVERBmodule
is disabled. Stop the rhythm and exit rhythm mode
tousethereverbeffect(→P17).
● Thedelayeffectisnotworking
If the looper isactivated,the DELAY module is
disabled.Stopusingthelooper(→P15).
● Theexpressionpedalisnotworkingwell
• Checktheexpressionpedalsettings(→P27).
• Adjusttheexpressionpedal(→P28).
● TherecordedlevelinaDAWislow
Checktherecordinglevelsetting(→P30).
● Batterieslosetheirchargequickly
• Are you using manganese batteries? Alkaline
batteriesshouldprovide6.5hoursofoperation.
• Checkthebatterysetting(→P31).Setthetypeof
battery being used for a more accurate display of
the remaining charge.

Related product manuals