Setting the date and time (first time starting up)
The first time the power is turned on after purchase as well as after the H4essential has been reset to
factory defaults, set the date and time when a screen to set them is shown after setting the date format.
The date and time are stored in recording files.
1. Use to select the item to set and press .
2. Use to change the value, and press .
3. Repeat steps 1–2 to set the date and time.
4. After setting all the items, use to select and press .
After the date and time setting is confirmed, set the battery type when a screen to set it opens. (→
Setting the type of batteries used (first time starting up))
NOTE
If power is not supplied for a long time, the date and time settings stored in the unit will be reset. If the Set
Date/Time Screen appears during startup, set them again.
41
To Next Page
Loading...
Need help?
General
