Track recording
R16 recording ow • Creating a new project
With multitrack recording you can create a complete work of music using the R16.
To begin, create a new project for each piece.
Connecting instruments and making monaural settings
You will need to adjust settings for musical instruments such as high impedance guitars, line input
synthesizers, the built-in microphones and microphones that use phantom power, as well as stereo and
monaural inputs, for example.
NOTE
*Turn the [PHANTOM] switch on to provide +48V
power to INPUT 5 and 6. You can use either
INPUT 5 or 6 or both when the switch is ON.
*Use the fader that corresponds to the INPUT jack.
The signal from INPUT 1 goes to track 1/9.
*To use Track 9~16, switch the fader assignment by
pushing the [9 –16Tr] key.
*Depending on the INSERT EFFECT selection, the
output flow will change.
*Creating one stereo file from two faders requires
the use of the STEREO LINK setting.
Connect instruments to the
appropriate INPUT jacks
Recording preparation
Track recording
Make project and track settings
Create a new project
Select the INPUTS and the recording tracks
Set stereo links
Change track status (recording, play, mute)
Adjust input sensitivity using the [GAIN] controls
Performance preparation
Set PRE-COUNT/METRONOME
Set and use TUNER
Record the first tracks
Record standby—Record—Stop
Record more tracks
Overdubbing
Record standby—Record—Stop
Overdubbing
Playback of already recorded tracks
Connecting passive-type guitars
Signal to INPUT 1
Connect high impedance (Hi-Z) instruments to
INPUT 1, and the turn the [Hi-Z] switch ON.
Connecting low-impedance
instruments (monaural connection)
Signals to any INPUT between 1~8
Connect low impedance instruments to any of the
INPUTS.
Create a new project
PROJECT>NEW
Change
menu
PROJECT
>SELECT
1
Press [PROJECT].
PROJECT
>NEW [SD]003:22:52]
Select
2
Press [ENTER].
No.003:PRJ003
Create?
Press [ENTER].
5
Execute.
HINT
You can change the new project name at Step 3.
Press [ENTER].
3
Confirm the PROJECT name.
Project No.003
PRJ003
New project name
New project number
Change
letters
Press [ENTER].
Select whether to use the settings of
the last project.
4
Change
menu
SETTING?
[CONTINUE] RESET
Select this to restore the default values
Ref: STEREO setting
P.19
Set tracks to receive INPUTS
INPUT TRACK
[1~8Tr] active [9~16Tr] active
1 1 9
2 2 10
3 3 11
4 4 12
5 5 13
6 6 14
7 7 15
8 8 16
Assign INPUT 1–8 connections to
tracks 1–16
1
Connect instruments and microphones
to jacks
INPUT 1 – 8
Select the Track switches
3
Enable the faders
either for tracks
1–8 or 9–16
TRACKS 1~8
TRACKS 9~16
4
Press the status key of a track one or two
times to turn the red light on.
Change the status of the connected
INPUTS
Red light on: recording enabled (REC)
>NEW
.
Press the [1-8Tr] or [9-16Tr] key to set which tracks
will record the INPUTS.
Supply phantom power to INPUT
5 and 6 jacks
Using phantom power
2
Make settings for specific instruments,
built-in microphones and stereo tracks.
PHANTOM
STEREO
MICHi-Z
MONAURAL×2
MONAURAL
Ref: Name change
P.43
Using the previous settings
P.57
To Next Page
Loading...
