Automatic punch-in/punch-out
The punch-in and punch-out functions enable you to pick already recorded portions of a recorded file
and re-record them. You can set the beginning and ending points of the portion in advance and record
automatically with punch-in at the beginning and punch-out at the ending.
Manual punch-in/punch-out
You can punch in and out manually. Press the [REC] key during playback to start re-recording from that
point.
NOTE
•
Once you make auto punch-in/out settings, you
cannot change the points. To change the points you
must cancel and reset them.
•
Press the [AUTO PUNCH IN/OUT] key again to
cancel the points set.
Prepare the track you want to
re-record with punch-in/punch-out
Make punch-in and punch-out settings
4
Using [REW], [FF] and [PLAY]
locate the point just before
the re-recording (PUNCH IN).
6
Pressing [FF] & [PLAY], locate
the punch-out point.
Re-recorded portion.
Recording again Recording again
NOTE
• Punch-in/punch-out recording overwrites the
existing recording. A previously recorded file
should be assigned to the track.
• You can use the [UNDO/REDO] function.
5
Set the punch-
in point.
Press [AUTO
PUNCH I/O]
Icon blinks
Re-recording track
1
Raise the fader
2
Press [PLAY/MUTE/REC]
1-2 times until the red light
turns on.
Red light on: recording enabled
Adjust the recording
level and the GAIN to
be the same as the
already recorded part.
3
Re-recording a track
1
Raise the fader.
2
Press [PLAY/MUTE/REC]
1-2 times until the red light
is on.
Red light on: recording enabled
Adjust the recording
level and the GAIN to
be the same as the
already recorded part.
3
7
Set the punch-
out point.
Press [AUTO
PUNCH I/O]
Icon lights
Rehearse
When the punch-in point is passed, the [MUTE]
function of the track automatically starts.
When the punch-out point is passed, the [MUTE]
function is released.
Perform (not recording)
1
Press [PLAY]
to start playing.
Light on
2
Press [STOP]
to stop.
Light off.
Press [REC] and then
[PLAY] to start playback.
9
8
Move to before the
PUNCH IN point.
10
Press [STOP]
to stop.
The recorder stops.
Light off
Re-recording: punch-in/punch-out
Light on Blinks
Not
recording.
Pass the punch-out point
Light on Blinks
Not
recording.
Pass the punch-in point
Performance Recording.
Lights on
11
Press [AUTO PUNCH I/O].
Icon off
Release PUNCH IN/OUT
Prepare the track for punch-in/
punch-out
4
Using [REW], locate the point just
before where you want to re-record.
Re-recording: punch-in/punch-out
5
Press [PLAY] to start
playback.
Light on
Start performance,
not yet recording
Perform and record.
Stop
Re-recorded portion
Start
Press [REC]
to start recording,
(punch-in)
Lights
on
6
Press [STOP]
to stop.
The recorder stops.
Lights off
8
Press [REC]
to stop
recording/start playback
(punch out).
Light on Light off
7
To Next Page
Loading...
