16-track synchronized recording by connecting two R16s
If you want to record more then 8 tracks at the same time for a band performance, for example, you can
increase the number of tracks by connecting two R16s with a USB cable.
1
Press [TOOL].
1
Press [TOOL].
Command keys that effect both sender and receiver.
PROJECT
>SYSTEM
Change
menus
Select
2
Press [ENTER].
PROJECT
>SYSTEM
Change
menus
Select
2
Press [ENTER].
SYSTEM
>SYNC REC
Change
menus
Select
3
Press [ENTER].
SYSTEM
>SYNC REC
Change
menus
Select
3
Press [ENTER].
Make sender settings.
Set the R16 that will be used for key control as the Master.
Make receiver settings.
Set the R16 that receives commands as the Slave.
Master/Slave
Select
4
SYNC REC
>Master
Press [ENTER].
USB Indicator: [HOST] light on
Master/Slave
Press [ENTER].
Select.
4
SYNC REC
>Slave
USB Indicator: [DEVICE] light on.
5
Connect two R16 with a USB cable.
Tool
NOTE
• Perfect synchronization of the start timing in
recording by two R16s is not guaranteed.
• There will be a gap of approximately 1-2 ms.
[REC] key [FF] key
[PLAY] key [REW] key
[STOP] key
Plug a USB 2.0 (AB-type) cable into the
socket that has a lit indicator.
HINT
R16 mixing procedure flow
Use the track mixer to make stereo link settings, to adjust sound volume, EQ and PAN (balance), and to
adjust the send signal strength, which affects the depth of send return effects.
HINT
What is the track mixer?
• This mixer can mix audio tracks from the recorder
into stereo.
• You can adjust the sound volume and PAN and
EQ parameters of each track using its fader.
NOTE
• When you are using a stereo track, except for the
phase setting, parameter values are shared by
both L and R channels.
Select the SEND-
RETURN EFFECT patch
Adjust the
SEND-RETURN EFFECT
Adjust volume, EQ and
PAN of sounds
Apply the insert effect
to tracks
Mix down
Mixing
Tool>System>Sync rec
>SYSTEM
.
>SYNC REC
>Master
.
>SYSTEM
>SYNC REC
>Slave
.
.
. .
The recorder (recording)
The track mixer
Mix down
Master track (recording)
To Next Page
Loading...
