Insert effects and send return effects are selected and
adjusted the same way.
You can select the most appropriate modules from the
algorithms, edit types and parameters and use saved
patches.
There are a few major differences between the two
types of effects when making settings. For an INSERT
EFFECT, you select a patch and set the insertion
point. For a SEND RETURN EFFECT, you adjust the
send level of the signals using the mixer.
Other functions are “IMPORT” to get patches from
another project and “REC SIGNAL” to apply the effect
only to monitoring.
The use procedures of effects are the same when
using the R16 as an audio interface and control
surface, but the patches are initialized when the unit is
not used as a recorder.
Input/output of the insert and send return effects
There are 2 types of effects processors built in to the R16—insert effects and send return effects. You
can use them at the same time.
Track
Input
Insert effect points
INSERT EFFECT
SEND RETURN EFFECT
Master
Insert effect signal flow
Uses of effects and patches Select effect & patch
Send return effect signal flow
INPUT 1-8 TRACK 1-16
Put the insert effect on a monaural input and
output in monaural.
You can use insert effects on
specific channels.
The built-in effects in the send return
effect of the mixer.
Send level
(Signal volume sent to
the effect)
You can select inputs to apply effects to
signals before recording them to recorder
tracks.
Apply processing to the playback sound of
any audio tracks in the track mixer.
Mix (return) with the original sounds of
the sent track.
Process the final stereo mix just before
the [MASTER] fader (signals recorded
to the master track).
The recorder (recording)
REVERB
The track mixer
Mix down
The master track (recording)
1
Press until the red light turns on.
Press [PLAY/
MUTE/REC].
Red light on.
Effect
INSERT EFFECT
Algorithm name
on display
Number of patches
(programmed patches)
Algorithm suitable for guitar/bass recording
CLEAN
30(22)
DISTORTION
50(40)
ACO/BASS SIM
20(10)
BASS
30(20)
For microphone recording, such as vocals
MIC
50(30)
For 2 independent channels (2 mono inputs/outputs)
DUAL MIC
50(30)
For recording synthesizers, electric pianos and other line-
output instruments
STEREO
50(40)
Algorithm with 8 independent channels of input/output
8×COMP EQ
20(10)
Processing for final stereo mixes
MASTERING
30(21)
SEND RETURN EFFECT
Algorithm name
on display
Number of patches
(programmed patches)
Process final stereo mix signals
CHORUS/DELAY
30(18)
Process final stereo mix signals
REVERB
30(22)
CHORUS/DELAY
Effect
<INSERT EFFECT>
<SEND EFFECT>
3
Select the algorithm.
Algorithm name
Patch number: Patch name
Insert effect example
Insert effect
insertion point
Change
algorithm
CLEAN <IN1>
No.00:Standard E
E (edit mark): items
are already edited
CLEAN, DISTORTION,
ACO/BASS
SIM,
BASS, MIC,
DUAL MIC, STEREO,
8x
COMP
EQ,
MASTERING
Send return effect example
SEND CHORUS/DELAY
No.00:ShortDLY
CHORUS/DELAY
REVERB
Ref.: Insert effect position
P.49
Press [ENTER] to turn on/off.
2
or
Press [INSERT EFFECT] or [SEND RETURN EFFECT].
EDIT
P.51
IMPORT
P.54
INPUT SOURCE
P.49
REC SIGNAL
P.55
Press [ ].
4
Select the patch.
CLEAN <IN1>
No.15:Standard E
Change patch
To Next Page
Loading...
