1
Press the forward or backward
mark key until you reached the
desired mark.
PRJ01 PRJ001
03 00:12:00:037
NOTE
• Once you delete a mark, you cannot retrieve it.
• You cannot delete the top mark
00.
Using the counter and markers to move (locate)
The counter indicates recording time and elapsed time in hour/minute/second/millisecond and bar/beat/
tick (1/48beat). Use it to set marks that you can then quickly move (locate) to in your project.
Place a mark Locate to the position of a mark Delete a mark
Locate a time or position using
the counter
Preparation: Stop the recorder.
Select the project.
Start from the top screen.
HINT
• After Step 3 you can start playback from the set
counter value.
NOTE
• You cannot use these procedures during recording/
playback.
In the middle of recording/playback
1
Select hour: minute: second or
bar-beat-tick.
Hour: minute: second: millisecond
Switch
PRJ01 PRJ001
00 00:00:00:000
Bar- beat- tick (1/48 beat)
Switch
PRJ01 PRJ001
00 00 - 00 - 000
3
Change the values.
Move between
items
PRJ01 PRJ001
00 00:15:00:000
HINT
Mark icon display
Counter is at the indicated mark
No mark registered at this counter position
Mark Numbers
Mark 0 = Counter 0. This is the head of the
project. You cannot change this particular mark.
• If you place a new mark ahead of a registered
mark, all the following marks will be automatically
renumbered in order.
• You can place a maximum of 100 marks in one
project.
ト03 000:10:08:015
Mark number 3 is located at 10 minutes, 8 seconds, 15
milliseconds.
PRJ01 PRJ001
01 00:01:12:037
Marker icon
Mark number
1
Press [MARK/CLEAR].
Start from the top screen.
Set the counter to the
desired mark position.
Move between
items
PRJ01 PRJ001
00 00:01:12:037
PRJ01 PRJ001
00 00:06:19:004
1
PRJ01 PRJ001
03 00:12:00:037
Press the forward and backward
mark keys until you reach the
desired mark.
The selected (highlighted) mark is erased and the
preceding mark is shown (the counter does not move).
PRJ01 PRJ001
02 00:12:00:037
Press [MARK/CLEAR].
2
Choose a mark.
1
PRJ01 PRJ001
00 00:00:00:000
Blinks
Move between
items
2
PRJ01 PRJ001
03 00:12:00:037
Choose the mark number.
HINT
• If you press the [MARK/CLEAR] key at a place
where a mark exists (mark icon highlighted), that
mark is deleted. If there is no mark at a location
(icon not highlighted), a new mark is placed there.
To delete a mark, you must move to it first (mark
icon highlighted).
• When placing and deleting marks, numbers are
automatically given in order from the beginning.
Not possible
to change
New mark is added
Mark is deleted
PRJ01 PRJ001
01 00:06:19:004
1
Press [MARK/CLEAR].
2
PRJ01 PRJ001
00 00:00:00:000
Move between units, the
selected item blinks
Choose the desired unit.
(Hour: minute: second: millisecond
or bar-beat-tick.)
Project
To Next Page
Loading...
