Zte MF985U - Page 31

MF985U User Manual

IP Settings:
Select IPv4 or IPv6.

MAC Address:
Set the MAC address that will be filtered.

Source IP Address:
Set the source IP address that will be filtered.

Dest. IP Address:
Set the destination IP address that will be filtered.

Protocol:
Set which protocol will be used for filtering.

Action:
Set how to handle the packet if it matches with th

Comment:
Type a comment for the filter settings.
NOTE:
If rules are in conflict with each other, the first to be triggered will determine how that
traffic is handled.
3. Click Apply
to confirm your configuration.
To add a new rule:
1. Select Enable,
Accepted
2. Click Apply.
3.
Input the detailed information in the
4. Click Apply in the
MAC/IP/Port Filtering Settings
Current MAC/IP/Port Filtering Rules
To delete a rule:
1.
Click the rule which you want to delete in
System area.
2. Click Delete
to delete the rule which you selected.

Port Mapping
1. Click >
Firewall > Port Mapping
following figures.
Confidential and Proprietary Information of ZTE CORPORATION
Select IPv4 or IPv6.
Set the MAC address that will be filtered.
Set the source IP address that will be filtered.
Set the destination IP address that will be filtered.
Set which protocol will be used for filtering.
Set how to handle the packet if it matches with the rule.
Type a comment for the filter settings.
If rules are in conflict with each other, the first to be triggered will determine how that
to confirm your configuration.
Accepted
or Dropped in the Port Filtering
area.
Input the detailed information in the
MAC/IP/Port Filtering
Settings
MAC/IP/Port Filtering Settings
area. The rule will display in the
Current MAC/IP/Port Filtering Rules
in System area.
Click the rule which you want to delete in Current MAC/IP/Port Filtering Rules in
to delete the rule which you selected.
Firewall > Port Mapping, the Port Mapping section
Confidential and Proprietary Information of ZTE CORPORATION
29
Set the source IP address that will be filtered.
Set the destination IP address that will be filtered.
e rule.
If rules are in conflict with each other, the first to be triggered will determine how that
area.
Settings
area.
area. The rule will display in the
Current MAC/IP/Port Filtering Rules in
, the Port Mapping section
is shown in the