EasyManua.ls Logo

Zultys MG4 Series User Manual

Default Icon
42 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
08
Fall
Z u l t y s , I n c . 7 7 1 V a q u e r o s S u n n y v a l e , C a l i f o r n i a , U S A 9 4 0 8 5 w w w . z u l t y s . c o m
Author: Zultys Technical Support Department
This document covers basic set up of the following Media Gateway models MG4/S, MG8/S, MG4/O,
MG8/O, MG8/SO (MG will designate any model in this series) in conjunction with the MX250 and MX30.
This document is based on MG gateways with software revision 1.9.82.306.X and MX system with
software revision 6.0.
It is assumed the reader is familiar with creating Users, Devices, Assignments, SIP Servers on the MX
system and is a current ZCSE Technician. Basic Telephony and Basic Networking is assumed as well.
Consult Media Gateway installation Guidefor installation procedures. Consult MG User Configuration
Guide for description of features not present in this manual.
It is strongly recommended that the MX is configured PRIOR to integrating the Media Gateways to prevent
the IP address of the Media Gateway being blocked by the MX.
MG Gateways must be configured with Microsoft® Internet Explorer®. At this time, FireFox®, Safari® and
other internet browsers are not supported by the current revision of MG Gateway software.
July
11
MG4 & MG8 Series Gateway Setup
Manual
Z
Technical Publications

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Zultys MG4 Series and is the answer not in the manual?

Zultys MG4 Series Specifications

General IconGeneral
ModelMG4 Series
Humidity10% to 90% non-condensing
TypeGateway
ProtocolsSIP, RTP
CodecsG.711, G.729, G.726
Operating Temperature0°C to 40°C

Summary

Configure MG Ports

MX250/30 Setup

Setup instructions for MX250/30.

Create Users for MX250/30

Create a user for each FXS (SLT) port of the MG gateway.

Create Devices for FXS/FXO Ports

Create a device for each FXS/FXO port of the Gateway.

Create Generic SIP Profile

Create a new Generic SIP profile before creating devices for Gateway.

Create MG Devices

Create the same number of devices the gateway can support.

Assign Users to MG Devices

Assign users to the devices.

Connect MG Gateway to Network

Basic Settings for MG

IP Addressing Configuration

Configure the IP address, Netmask, and Gateway IP.

FXS Settings

Configure FXS Line Features

Configure FXS line settings like phone number, registration, and features.

SIP Trunk Configuration

Routing Configuration

SIP Protocol Settings

Troubleshooting MG