Chapter 12 Wireless LAN
WAP6806 User’s Guide
71
4 Log into the WAP6806’s Web Configurator. Make sure WPS is enabled in the Configuration >
Network > Wireless LAN > WPS screen.
5 Navigate to Configuration > Network > Wireless LAN > WPS and select the PBC.
Note: Your WAP6806 has a WPS button located on its panel, as well as a WPS button in
its configuration utility. Both buttons have exactly the same function; you can use
one or the other.
Note: It doesn’t matter which button is pressed first. You must press the second button
within two minutes of pressing the first one.
The WAP6806 sends the proper configuration settings to the wireless client. This may take up to
two minutes. Then the wireless client is able to communicate with the WAP6806 securely.
The following figure shows you how to set up wireless network and security by pressing a button on
both WAP6806 and wireless client (the NWD-211AN in this example).
Figure 56 Example WPS Process: PBC Method
12.7.1.2 PIN Configuration
When you use the PIN configuration method, you need to use both WAP6806’s configuration
interface and the client’s utilities.
Wireless Client
SECURITY INFO
COMMUNICATION
WITHIN 2 MINUTES
AP
To Next Page
Loading...
