Chapter 12 Wireless LAN
WAP6806 User’s Guide
72
The push button configuration function is only available in AP mode.
1 Launch your wireless client’s configuration utility. Go to the WPS Station settings and select the PIN
method to get a PIN number.
2 On the WAP6806, navigate to the Network > Wireless LAN (2.4G/5G) > WPS screen.
3 Obtain the PIN number for the WAP6806 or press the Generate New PIN button to create a new
PIN number. See Section 12.7 on page 69.
4 Enter the WAP6806 PIN number in the wireless station’s utility screen.
The WAP6806 authenticates the wireless client and sends the proper configuration settings to the
wireless client. This may take up to two minutes. Then the wireless client is able to communicate
with the WAP6806 securely.
The following figure shows an example of how to set up wireless network and security on WAP6806
and wireless client (ex. NWD210N in this example) by using PIN method.
To Next Page
Loading...
