ZyXEL Communications SBG3300-N000 - 6.7 The multi-WAN Screen

Chapter 6 Broadband
SBG3300-N Series User’s Guide
139
6.6.1 Edit 802.1x Settings
Use this screen to edit a 802.1x authentication’s settings. Click the Edit icon next to the rule you
want to edit. The screen shown next appears.
Figure 30 802.1x: Add/Edit
The following table describes the labels in this screen.
6.7 The multi-WAN Screen
Use the multi-WAN screen to configure the multiple WAN load balance and failover rules to
distribute traffic among different interfaces. This helps to increase overall network throughput and
reliability. Load balancing divides traffic loads between multiple interfaces. This allows you to
improve quality of service and maximize bandwidth utilization for multiple ISP links.
Table 16 802.1x: Add/Edit
LABEL DESCRIPTION
Active This field allows you to activate/deactivate the authentication.
Select this to enable the authentication. Clear this to disable this authentication without
having to delete the entry.
Interface Select the interface that uses the authentication.
EAP Identity Enter the EAP identity of the authentication.
EAP method This is the EAP method used for this authentication.
Enable
Bidirectional
Authentication
Select this to allow bidirectional authentication.
Certificate Select the certificate you want to assign to the authentication. You need to import the
certificate in the Security > Certificates > Local Certificates screen.
Trusted CA Select the Trusted CA you want to assign to the authentication. You need to import the
certificate in the Security > Certificates > Trusted CA screen.
Apply Click Apply to save your changes.
Cancel Click Cancel to exit this screen without saving.