ZyXEL Communications SBG3300-N000 - Configuring the Default_L2 Tpvpn Ipsec VPN Rule (Server)

Chapter 4 Tutorials
SBG3300-N Series User’s Guide
86
The example uses the following settings in setting up a basic L2TP VPN tunnel.
Figure 15 L2TP VPN Example
• The Device has a static IP address of 172.16.1.2 for the DSL WAN interface.
• The remote user has a dynamic IP address and connects through the Internet.
• Use the default IP address pool to assign the remote users a point-to-point IP addresses from
10.2.1.1 to 10.2.1.32 for use in the L2TP VPN tunnel.
• The access group configuration allows the remote L2TP user to access only the LAN subnet
192.168.2.0/24.
4.13.1 Configuring the Default_L2TPVPN IPSec VPN Rule (Server)
1 Go to the VPN > IPSec VPN screen which lists the VPN rules. Click the Edit icon of the
Default_L2TPVPN entry.
2 Select the Enable checkbox.
3 Select Pre-Shared Key and configure a password. This example uses 1234567890.
172.16.1.2
LAN Subnet #1: 192.168.1.0/24
LAN Subnet #2: 192.168.2.0/24
L2TP VPN IP Address Pool:
10.2.1.1 - 10.2.1.32