SBG3300-N Series User’s Guide 243
CHAPTER 13
Interface Group
13.1 Overview
By default, the four LAN interfaces on the Device are in the same group and can communicate with
each other. Creating a new interface will create a new LAN bridge interface (subnet) (for example,
192.168.2.0/24) that acts as a dependent LAN network, and is a different subnet from default LAN
subnet (192.168.1.0/24).
13.2 The Interface Group Screen
You can manually add a LAN interface to a new group. Alternatively, you can have the Device
automatically add the incoming traffic and the LAN interface on which traffic is received to an
interface group when its DHCP Vendor ID option information matches one listed for the interface
group.
Use the LAN screen to configure the private IP addresses the DHCP server on the Device assigns to
the clients in the default and/or user-defined groups. If you set the Device to assign IP addresses
based on the client’s DHCP Vendor ID option information, you must enable DHCP server and
configure LAN TCP/IP settings for both the default and user-defined groups. See Chapter 8 on page
177 for more information.
Use the Interface Group screen to create a new interface group, which is a new LAN bridge
interface (subnet). Click Network Setting > Interface Group to open the following screen.
Figure 91 Network Setting > Interface Group
The following table describes the fields in this screen.
Table 68 Network Setting > Interface Group
LABEL DESCRIPTION
Add New
Interface Group
Click this button to create a new interface group.
Group Name This shows the descriptive name of the group.
LAN Interfaces This shows the LAN interfaces in the group.
To Next Page
Loading...
