Chapter 4 Tutorials
SBG3300-N Series User’s Guide
65
Note: The Peer Gateway Address is not shown in the screen because it is an unknown
IP address to the remote access VPN client.
Note: The policy for the remote VPN client is not shown in the screen because it is an
unknown to the remote access VPN client.
4.12 PPTP VPN Tutorial
The example uses the following settings in setting up a basic PPTP VPN tunnel.
Figure 14 PPTP VPN Example
• The Device has a static IP address of 172.16.1.2 for the DSL WAN interface.
• The remote user has a dynamic IP address and connects through the Internet.
• Use the default IP address pool to assign the remote users a point-to-point IP addresses from
10.1.1.1 to 10.1.1.32 for use in the PPTP VPN tunnel.
• The access group configuration allows the remote user to access only the LAN subnet #1
192.168.1.0/24.
4.12.1 Configuring PPTP VPN Setup (Server)
1.Go to the VPN > PPTP VPN > Setup screen and configure the following.
• Select the Enable checkbox.
•Set Access Group 1 to 192.168.1.0/255.255.255.0.
•Select DNS as User Defined and enter a DNS server address. The DNS server address in this
example is 8.8.8.8.
172.16.1.2
LAN Subnet #1: 192.168.1.0/24
LAN Subnet #2: 192.168.2.0/24
PPTP VPN IP Address Pool:
10.1.1.1 - 10.1.1.32
To Next Page
Loading...
