ZyXEL Communications SBG3300-N000 - Add;Edit an ACL Rule

Chapter 15 Firewall
SBG3300-N Series User’s Guide
257
15.4.1 Add/Edit an ACL Rule
Click Add new ACL rule or the Edit icon next to an existing ACL rule in the Access Control
screen. The following screen displays.
Figure 101 Access Control: Add/Edit
The following table describes the labels in this screen.
Table 76 Access Control: Add/Edit
LABEL DESCRIPTION
Filter Name Enter a descriptive name of up to 16 alphanumeric characters, not including spaces,
underscores, and dashes.
You must enter the filter name to add an ACL rule. This field is read-only if you are editing
the ACL rule.
Order Select the order of the ACL rule.
Direction Select the direction of the ACL rule. You may select from WAN to LAN, WAN to Router,
WAN to DMZ, LAN to WAN, LAN to Router, LAN to DMZ, DMZ to WAN, DMZ to LAN,
and DMZ to Router. The DMZ zone is available when there's a specified DMZ group.
Select Source
Device
Select the source device to which the ACL rule applies. If you select Specific IP Address,
enter the source IP address in the field below.
Source IP
Address
Enter the source IP address.
Select
Destination
Device
Select the destination device to which the ACL rule applies. If you select Specific IP
Address, enter the destiniation IP address in the field below.
Destination IP
Address
Enter the destination IP address.
IP Type Select whether your IP type is IPv4 or IPv6.