Chapter 1 Introducing the Device
SBG3300-N Series User’s Guide
21
1.6 The RESET Button
If you forget your password or cannot access the web configurator, you will need to use the RESET
button at the back of the device to reload the factory-default configuration file. This means that you
will lose all configurations that you had previously and the password will be reset to “1234”.
1 Make sure the POWER LED is on (not blinking).
2 To set the device back to the factory default settings, press the RESET button for ten seconds or
until the POWER LED begins to blink and then release it. When the POWER LED begins to blink,
the defaults have been restored and the device restarts.
1.7 Wireless Access
The Device is a wireless Access Point (AP) for wireless clients, such as notebook computers or PDAs
and iPads. It allows them to connect to the Internet without having to rely on inconvenient Ethernet
cables.
You can configure your wireless network in either the built-in Web Configurator.
Figure 4 Wireless Access Example
1.7.1 Using the WLAN Button
If the wireless network is turned off, press the WLAN button at the front of the Device for one
second. Once the WLAN LED turns green, the wireless network is active.
To Next Page
Loading...
