Chapter 6 Broadband
SBG3300-N Series User’s Guide
140
You can only configure one rule for each interface. Click Network Setting > Broadband > multi-
WAN to display the following screen.
Figure 31 Network Setting > Broadband > multi-WAN
The following table describes the labels in this screen.
6.7.1 Add/Edit multi-WAN
Click Add New Entry in the multi-WAN screen or the Edit icon next to an existing multi-WAN rule
to configure it.
Figure 32 multi-WAN: Add/Edit
Table 17 Network Setting > Network Setting > multi-WAN
LABEL DESCRIPTION
Add New Entry Click this button to add a previously removed multi-WAN rule entry. By default, adding new
WAN interfaces to the system will generate a corresponding rule entry on this page in active
mode with a weight of 1. Each interface can have only one rule. If the interface you want to
configure already has a rule, you can edit it, or you can delete it before configuring a new
rule.
# This is the index number of the entry.
Interface This is the interface that uses the rule.
Mode This shows whether the rule is Active or Passive.
Weight This shows the weight of the rule.
Modify Click the Edit icon to configure the multi-WAN rule.
Click the Delete icon to remove the multi-WAN rule.
To Next Page
Loading...
