ZyXEL Communications XGS1930-52HP - Spanning Tree Configuration; Configure Rapid Spanning Tree Protocol

XGS1930 Series User’s Guide
132
This screen differs depending on which STP mode (RSTP or MSTP) you configure on the Switch. This screen
is described in detail in the section that follows the configuration section for each STP mode. Click
Configuration to activate one of the STP standards on the Switch.
13.3 Spanning Tree Configuration
Use the Spanning Tree Configuration screen to activate one of the STP modes on the Switch. Click
Configuration in the Advanced Application > Spanning Tree Protocol.
Figure 98 Advanced Application > Spanning Tree Protocol > Configuration
The following table describes the labels in this screen.
13.4 Configure Rapid Spanning Tree Protocol
Use this screen to configure RSTP settings, see Section 13.1 on page 129 for more information on RSTP.
Click RSTP in the Advanced Application > Spanning Tree Protocol screen.
Table 59 Advanced Application > Spanning Tree Protocol > Configuration
LABEL DESCRIPTION
Spanning Tree
Mode
You can activate one of the STP modes on the Switch.
Select Rapid Spanning Tree or Multiple Spanning Tree. See Section 13.1 on page 129 for
background information on STP.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.