Chapter 3 Hardware Panels
XGS1930 Series User’s Guide
30
3 Press the transceiver firmly until it clicks into place.
4 The Switch automatically detects the installed transceiver. Check the LEDs to verify that it is functioning
properly.
5 Close the transceiver’s latch (latch styles vary).
6 Connect the fiber optic cables to the transceiver.
Figure 12 Transceiver Installation Example
Figure 13 Connecting the Fiber Optic Cables
3.1.3.2 Transceiver Removal
Use the following steps to remove an SFP/SFP+ transceiver.
1 Remove the fiber optic cables from the transceiver.
2 Open the transceiver’s latch (latch styles vary).
3 Pull the transceiver out of the slot.
Figure 14 Removing the Fiber Optic Cables
Figure 15 Opening the Transceiver’s Latch Example
To Next Page
Loading...
