Chapter 26 Loop Guard
XGS1930 Series User’s Guide
209
26.2 Loop Guard Setup
Click Advanced Application > Loop Guard in the navigation panel to display the screen as shown.
Note: The loop guard feature can not be enabled on the ports that have Spanning Tree
Protocol (RSTP or MSTP) enabled.
Figure 146 Advanced Application > Loop Guard
The following table describes the labels in this screen.
Table 97 Advanced Application > Loop Guard
LABEL DESCRIPTION
Active Select this option to enable loop guard on the Switch.
The Switch generates syslog, internal log messages as well as SNMP traps when it shuts down a
port via the loop guard feature.
Port This field displays the port number. * means all ports.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
To Next Page
Loading...
