Chapter 31 Link Layer Discovery Protocol (LLDP)
XGS1930 Series User’s Guide
250
Figure 174 Advanced Application > LLDP > LLDP-MED Configuration
The following table describes the labels in this screen.
31.8 LLDP-MED Network Policy
Click Advanced Application > LLDP > LLDP-MED Network Policy (Click Here) to display the screen as
shown next.
Table 124 Advanced Application > LLDP > LLDP-MED Configuration
LABEL DESCRIPTION
Port This displays the Switch’s port number. Select * to configure all ports simultaneously.
* Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Notification
Topology
Change
Select to enable LLDP-MED topology change traps on this port.
MED TLV Setting
Location Select to enable transmitting LLDP-MED location TLV.
Network Policy Select to enable transmitting LLDP-MED Network Policy TLV.
Apply Click Apply to save the changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
