Chapter 33 DHCP
XGS1930 Series User’s Guide
260
33.2 DHCP Configuration
Click IP Application > DHCP in the navigation panel to display the screen as shown. Click the link next to
DHCPv4 to open screens where you can enable and configure DHCPv4 relay settings and create option
82 profiles. Click the link next to DHCPv6 to open a screen where you can configure DHCPv6 relay
settings.
Figure 181 IP Application > DHCP
33.3 DHCPv4 Status
Click IP Application > DHCP > DHCPv4 in the navigation panel. The DHCP Status screen displays.
Figure 182 IP Application > DHCP > DHCPv4
The following table describes the labels in this screen.
Table 129 IP Application > DHCP > DHCPv4
LABEL DESCRIPTION
Relay
Status
This section displays configuration settings related to the Switch’s DHCP relay mode.
Relay
Mode
This field displays:
None - if the Switch is not configured as a DHCP relay agent.
Global - if the Switch is configured as a DHCP relay agent only.
VLAN - followed by a VLAN ID or multiple VLAN IDs if it is configured as a relay agent for specific
VLAN(s).
VID This field displays the ID number of the VLAN for which the Switch acts as a DHCP relay agent.
Current
Source
Address
This field displays the source IP address of the DHCP requests that the Switch forwards to a DHCP server.
To Next Page
Loading...
