XGS1930 Series User’s Guide
225
Figure 156 Advanced Application > Errdisable > Errdisable Status
The following table describes the labels in this screen.
Table 109 Advanced Application > Errdisable > Errdisable Status
LABEL DESCRIPTION
Inactive-reason mode reset
Port List Enter the number of the port(s) (separated by a comma) on which you want to reset inactive-
reason status.
Cause Select the cause of inactive-reason mode you want to reset here.
Reset Press to reset the specified port(s) to handle ARP, BPDU or IGMP packets instead of ignoring
them, if the port(s) is in inactive-reason mode.
Errdisable Status
Port This is the number of the port on which you want to configure Errdisable Status.
Cause This displays the type of the control packet received on the port or the feature enabled on the
port and causing the Switch to take the specified action.
Active This field displays whether the control packets (ARP, BPDU, and/or IGMP) on the port is being
detected or not. It also shows whether loop guard is enabled on the port.
Mode This field shows the action that the Switch takes for the cause.
• inactive-port - The Switch disables the port.
• inactive-reason - The Switch drops all the specified control packets (such as BPDU) on the
port.
• rate-limitation - The Switch drops the additional control packets the port(s) has to handle in
every one second.
To Next Page
Loading...
