XGS1930 Series User’s Guide
331
Figure 241 Management > Configure Clone
The following table describes the labels in this screen.
Table 172 Management > Configure Clone
LABEL DESCRIPTION
Source/
Destination
Port
Enter the destination port or ports under the Destination label. These are the ports which are going
to have the same attributes as the source port. You can enter individual ports separated by a
comma or a range of ports by using a hyphen. For example, 2, 4, 6 indicates that ports 2, 4 and 6
are the destination ports. 2-6 indicates that ports 2 through 6 are the destination ports.
Basic Setting Select which port settings (you configured in the Basic Setting menus) should be copied to the
destination port(s).
Advanced
Application
Select which port settings (you configured in the Advanced Application menus) should be copied
to the destination ports.
To Next Page
Loading...
